Garage Door Garage Door Sensor Installation Eatonton, GA

Garage Door Garage Door Sensor Installation Eatonton, GA

Eatonton garage door sensor installation, done by a crew that works this area daily. We see swollen, sticking wood doors in summer humidity, storm-driven debris and water in the tracks, moisture-tripped openers and sensors after storms, and corroded springs and cables in the humid air most often here, and we carry the parts to resolve them on the first visit.

We spec every Eatonton job for the environment it lives in. Given hot, humid summers and short, mild winters, with frequent storms and moisture that lingers in the air most of the year, the failure modes we plan around are summer heat and moisture that swell wood doors and seize rollers, salt-tinged coastal air that accelerates rust near the shore, and corrosion that creeps across hardware in the muggy air — and we carry the corrosion-resistant parts to match.

The calls we get most in Eatonton are swollen, sticking wood doors in summer humidity, storm-driven debris and water in the tracks, moisture-tripped openers and sensors after storms, and corroded springs and cables in the humid air. Each is something our trucks are stocked to fix on the first visit — no waiting on parts.

Photo-eye safety sensors are required by UL-325 on every garage door opener manufactured since 1993. They detect obstructions in the door's path and either reverse the door (during close) or refuse to start (when activated). When sensors are misaligned, dirty, sun-blinded, or failed, the door either refuses to close at all or — worse — closes without sensing an obstruction. Our sensor installation service replaces failed sensors, realigns drifted brackets, cleans the eye optics, and verifies auto-reverse on a real obstruction test.

Replacement eyes are brand-specific (LiftMaster has a different connector and signal pattern than Genie). We stock the major brands and most legacy models. Brackets occasionally need replacement when corrosion has degraded them or impact has bent them. Bracket alignment is critical — eyes that are slightly off-aim trigger intermittent close failures that drive homeowners crazy.

Every visit ends with an obstruction test: a 1.5-inch (3.8 cm) tall object placed under the door at three positions across the opening. The door must reverse when it touches the object. This is the UL-325 baseline — if the door doesn't pass, the install isn't complete. We document the test results on the work order.

Signs you need garage door sensor installation